Our picks at a glance

  1. Best oscillating clip fan

    AC Infinity CLOUDRAY S6

    325 CFM at 31 dBA and 11 W, 10 speeds, 10 dynamic wind modes and 10 oscillation ranges, IP54, and app control through AC Infinity's UIS controllers.

  2. Best for a Vivosun setup

    Vivosun AeroWave E6 Gen2

    320 CFM at 33 dBA and 12 W, 5-level auto oscillation over 90°, an IP54 rating and a clamp for 16–22 mm poles; app control via GrowHub.

  3. Simplest non-oscillating fan

    Hurricane Classic 6" Clip Fan

    306 CFM and 14 W on high, two speeds, adjustable tilt and a spring clamp, with no oscillation or controller to set up.

We do not list prices: they change daily. “Check price” opens the seller’s current listing.

On this page10 sections
  1. Our picks at a glance
  2. What to compare
  3. Specs side by side
  4. AC Infinity CLOUDRAY S6
  5. Vivosun AeroWave E6 Gen2
  6. Hurricane Classic 6” Clip Fan
  7. Placement tips
  8. How these picks were made
  9. FAQ
  10. Sources

An inline fan and carbon filter pull air out of a grow tent. They don’t do much to stir the air inside it. A clip fan clamps to a tent pole and keeps air moving across and under the canopy, so warm or humid pockets don’t settle around the leaves and stems get a gentle breeze.

This guide compares three 6-inch clip fans from their published specifications: two oscillating EC-motor fans built for grow tents, and a basic two-speed fan. We did not test them ourselves, and we found no independent airflow or noise measurements for these models.

What to compare

  • Airflow (CFM). All three are 6-inch fans in the 300 CFM range. In a tent the controls matter more than the last few CFM.
  • Oscillation. An oscillating fan covers more of the tent from one clamp. Range settings let you avoid blasting one plant.
  • Motor and power. EC motors offer many speed steps at low power. The two EC fans here are rated at 11 and 12 W.
  • Humidity rating. A tent is warm and humid. An IP54 rating means the fan is protected against dust and splashing water.
  • Clamp and controller. Check the clamp fits your poles, and whether the fan joins your existing controller.

Specs side by side

AC Infinity CLOUDRAY S6 Vivosun AeroWave E6 Gen2 Hurricane Classic 6”
Max airflow 325 CFM 320 CFM 306 CFM (high)
Rated noise 31 dBA 33 dBA Not stated
Power 11 W 12 W 14 W
Motor Brushless EC, dual ball bearings EC, dual ball bearings Not stated
Speeds 10, plus 10 dynamic wind modes 10 with app (5 without), normal and natural modes 2
Oscillation Automatic, 10 ranges, 90° rotation Automatic, 5 levels, 90° None (manual tilt)
Tilt 55° 80° vertical adjustment Adjustable
Rating IP54, ETL IP54 UL listed
Controller AC Infinity UIS (Controller 69 and others) Vivosun GrowHub E42/E42A/E25 Built-in switch
Cord 8 ft Not stated 5 ft

Figures are from AC Infinity’s and Vivosun’s product pages and Hurricane’s spec sheet (Hawthorne Gardening Company), checked November 14, 2026.

AC Infinity CLOUDRAY S6

AC Infinity lists 325 CFM maximum airflow at 31 dBA, 25 Pa static pressure, 11 W at 100–240 V, a brushless EC motor with carbon steel gears and dual ball bearings rated for 67,000 hours, IP54 protection and ETL safety certification. It offers 10 speeds, 10 dynamic wind modes that vary airflow to simulate outdoor wind, and 10 oscillation ranges across a 90° rotation, with a 55° tilt and horizontal or vertical mounting. Its operating range is 32 to 140 °F and 35 to 85% RH.

It plugs into AC Infinity’s UIS controllers, which add app control, climate triggers and timers. If your inline fan is a CLOUDLINE, one controller can run both.

Vivosun AeroWave E6 Gen2

Vivosun lists 320 CFM at 33 dBA and 12 W at 100–240 V, a dual ball bearing EC motor, IP54 protection, 5-level auto oscillation across 90°, an 80° vertical adjustment range and a built-in timer. It has 10 speed levels with the app (5 without) and normal and natural wind modes. Vivosun says it retracts automatically to avoid motor jams when the oscillation hits an obstacle, and its clamp fits round or square poles from 16 to 22 mm. App control needs a Vivosun GrowHub E42, E42A or E25 controller. Vivosun lists 2-year after-sale service.

It is the match for a tent already run by Vivosun’s GrowHub; see Vivosun vs AC Infinity for how the two ecosystems compare.

Hurricane Classic 6” Clip Fan

Hurricane’s spec sheet lists 306 CFM and 2,350 RPM on high, two speeds, adjustable tilt, a strong clamp, a 5 ft power cord, and a draw of 0.15 A and 14 W at 120 V. Hurricane’s product page adds that it is UL listed and has a metal grill and steel neck. It does not oscillate and has no controller input.

It is the budget way to add circulation. In a small tent, one fixed fan aimed across the canopy, or two aimed in opposite directions, does the basic job.

Placement tips

  • Across the canopy, not straight down. Aim for leaves that move gently, not leaves pinned flat.
  • Under the canopy too. In a tall tent, a second fan low down moves air under the leaves.
  • Away from the sensor. Keep the fan’s direct stream off your thermometer hygrometer so it reads the tent, not the breeze.
  • Leave the exhaust to the inline fan. A clip fan does not replace exhaust or a carbon filter; LONGWELL’s calculator sizes the inline fan and suggests how many clip fans to add.

How these picks were made

We compared two grow-tent oscillating clip fans and one basic clip fan on published airflow, oscillation, power, noise, protection rating and controller support. We did not test these fans ourselves; see how we research.

FAQ

Do I need a clip fan in a grow tent?

The inline fan exchanges the tent's air; a clip fan moves air around inside it, across and under the canopy, so warm, humid pockets don't sit around the leaves. Most tent setups use both.

How many clip fans does a grow tent need?

It depends on the tent size and how dense the canopy is. LONGWELL's fan calculator suggests how many clip or oscillating fans to add for a given tent. In a tall tent, a second fan mounted low moves air under the canopy as well as across it.

Should the clip fan blow directly on plants?

Aim for gentle movement across the canopy rather than a strong blast at one spot. Oscillation and low speed settings help; AC Infinity's dynamic wind modes and Vivosun's natural wind mode vary the airflow to mimic an outdoor breeze.

Is an oscillating clip fan worth it?

Oscillation spreads airflow across a wider area from one mounting point. The CLOUDRAY S6 lets you set one of 10 oscillation ranges and the AeroWave E6 has 5 levels over 90°. A fixed fan like the Hurricane Classic is cheaper to run and simpler, but covers less of the tent.

Will a clip fan fit my tent poles?

Check the clamp. Vivosun lists 16–22 mm poles for the AeroWave E6, and Hurricane uses a spring clamp. Tent poles vary: Vivosun lists 16 mm poles on its standard 4x4 kit tent, and 22 mm poles on its P448 Pro and on AC Infinity's CLOUDLAB 844.

Sources

Specs and measurements change between product revisions. We list the date we last checked each source.

  1. Manufacturer CLOUDRAY S6, Grow Tent Clip Fan 6" (AC-CCS6), product page, AC Infinity. Checked Nov 14, 2026.
  2. Manufacturer AeroWave E6 Gen2 grow tent clip fan 6", product page, Vivosun. Checked Nov 14, 2026.
  3. Manufacturer Hurricane Classic 6" Portable Clip Fan spec sheet (item 736520), Hawthorne Gardening Company. Checked Nov 14, 2026.
  4. Manufacturer Hurricane 6 Inch Clip Fan (HGC736520), product page, Hurricane. Checked Nov 14, 2026.
  5. Reference Grow tent fan size calculator: formulas, LONGWELL Fans. Checked Nov 13, 2026.
  6. Manufacturer Vivosun complete grow tent kit 4x4 (VSK-GIYE448G2), product page, Vivosun. Checked Nov 13, 2026. One feature bullet on the page mentions an R4 fan; the included-items list and spec table say R6.
  7. Retailer listing Vivosun P448 4x4 Grow Tent Pro, retailer listing with manufacturer specs, Hydrobuilder. Checked Nov 13, 2026.
  8. Manufacturer AC Infinity CLOUDLAB 844 advance grow tent 4x4, product page, AC Infinity. Checked Nov 13, 2026.